The customer asked, and we delivered.
Not readily available in aftermarket. These handmade parts worked perfectly.
Making a new pin to work with an altered O/U receiver. Worked perfectly
Don't let your gun get to this state.
This is not that uncommon.
Came from a cheap AP9 clone.
Repleced the broken polymer plate. Worked perfectly.
The expoded brass is 22 WMG which was jammed in a curved 22 LR feed tube. Pushed from the bullet end, it blew out just before it cleared the passage. No injuries.
The firing pin return spring did not return the firing pin, preventing proper loading. We took care of that.
Recoil pad installed, ground to fit, and polished.
Custom flash hider: 36 holes, 0.180 diameter, 10° apart, 0.400 linear spacing. Threaded 5/8-24 for his 308
Cleared these from his barrel. 8 pellets and a cleaning brush,
*Emergency calls available all the time!*
All Rights Reserved | H&M Gunsmith
